Gate Controls
ON: The Gate opens above this level
OFF: The Gate closes below this level
Reduction: The amount the signal is reduced when the Gate closes
Attack: The time taken to open the Gate (0-2000ms)
Hold: The Gate will remain open for this length of time (0-2000ms)
Release: The time taken to close the Gate (0-2000ms)
EQ1 & EQ2 Controls
Freq: The Filter frequency in Hz
Res: Amount of Resonance or Width (Parametric/Bpf)
Gain: Amount of Cut/Boost for the Parametric filter
Auto Panner Controls
Wave: Various different Waveforms. Alters the panning response
Panning Mode: Different Panning modes: Linear, Analogue1/2
Rate: Sets the speed of panning
Mode: Determines if 'Rate' is Hz or Beats(Host)
Depth: Affects the stereo panning width
Compressor Controls
Thresh: The level at which the compressor affects the signal
Ratio: The amount of compression
Gain: 'Make up gain' compensates for the compressor level reduction
Attack: Sets how quickly compression is applied
Release: Sets how quickly compression is removed
Stereo Image Controls
Centre: The level of the Centre or Mono signal
Edge: The level of the Egde or Side signal
Distortion/Limiter Controls
Drive: Adjusts the signal level going into the Distortion/Limiter
Thresh: The level at which the Distortion/Limiter affects the signal
Squash: Alters the response: 0= Clipper: 10= Soft: 20=Peak
Degrader Controls
Mode: Different degrade modes: Step, Linear, Curve and Bypass(Off)
Squash: Higher values increases the degradation amount
|
Controls
Decay: The Reverb Decay time(s)
Infinite Decay: When ON the Reverb does not decay
Decay Image: Different Decay settings*
Damp: Amount of decay damping (Low Pass Filter)
Size: Reverb size (Room/Hall etc.)
Reverb Core: Different Core settings for the Reverb*
Spatial: Sets the dispertion of echos in the main Reverb
Spatial Mode: Adjusts the relationship between 'Size' and 'Spatial'
Diff: Diffusion, 'smears' the input signal
Diff Stages: More stages increases the 'smearing' effect
Diff Image: Different Diffusion settings*
Density: Sets the dispertion of echos in the Diffusion
Pre Delay: Time before the Reverb sounds (0-500ms)
(*)Note: Only subtle differences are heard with short reverbs
Mod: Applies time variation into the Reverb which breaks up static sounds
Mod Mode: 'Mod' can be Mono(A) or Stereo(B)
Width: Adjusts the stereo image width
Balance: Controls the Balance between Left and Right Reverbs
Blend: Combines the Left and Right Reverbs, maintaining a Stereo image
Stereo Mode: Either Inline or Swapped stereo image
Filter Type: Numerous filter types available *See Synth Filter section
Freq: The Filter frequency in Hz
Res: Amount of Resonance or Width (Parametric/Bpf)
Gain: Amount of Cut/Boost for the Parametric filter
|
Controls
Time: Sets the Echo Time
Time Mode: Times can be set as Time(s) or Beats(Host)
Time Adjust: A 'Master' control to easily adjust all the Echo times
Level: Sets the Echo volume
Pan: Sets the Pan position (-5=Left, 0=Centre, +5=Right)
Time Feedback: Sets the Feedback Time
Level Feedback: Sets the Feedback level
Filter Mode: 'Pre' the filter is before the Echo
'Fbk' filters the Feedback signal
Filter Type: Numerous filter types available *See Synth Filter section
Freq: The Filter frequency in Hz
Res: Amount of Resonance or Width (Parametric/Bpf)
Gain: Amount of Cut/Boost for the Parametric filter
|
Controls
Voices: Sets whether the Chorus is 2, 3, or 4 Voices
Waveform: Various different modulation waveforms
Pre Delay: Delay before the chorus voice sounds (0-500ms)
Phase: Adjusts the initial modulation phase
Rate: Sets the modulation speed
Rate Mode: 'Rate' can be set as Hz or Beats(Host)
Depth: Chorus Depth(ms)
Feedback: Amount of Voice 1 chorus fed back into the Chorus
Feedback Mode: 'PreDly' allows discrete echos
'Chorus' allows flanging type fx
Width: Adjusts the stereo image width
|
Controls
Filter Type: Numerous filter types available *See Synth Filter section
Freq: The Filter frequency in Hz
Res: Amount of Resonance or Width (Parametric/Bpf)
Gain: Amount of Cut/Boost for the Parametric filter
|
Controls
Level: Sets the Ensemble volume
Width: Adjusts the stereo image width
Detune: Adjusts the depth of the Ensemble effect
Primary: Main stereo Ensemble circuit (On/Off)
Seconday: Second mono Ensemble circuit. Combines with Primary circuit when ON
Delay1/2/3: Applies Delay(0-500ms) at 3 points in the Ensemble circuit
|
|
